Classic Vinyl Fence Calculator

For Customer Service, Call 1-866-888-5350

This calculator will enable you to get an accurate material list for Classic Vinyl fence. Just follow the 7 steps.

This illustration points out that each line of fence, identified by the letters, is separate and distinctively different that the others for estimating purposes. Note that the side A-B, are two separate lines, since it does matter how much footage is on each side of the gate.

It does not matter that your fence project may not match the illustration. Make a similar drawing of your project and label the sides. This will help clarify your entries in the fields below.

Step 1:

Enter footage for each stretch. Fractions will not be calculated.
A: B: C: D: E: F:

G: H: I: J: K: L:

Step 2:

Enter corner posts. These posts have two panels attached to it forming a 90 degree angle. Include posts that create an angle nearer 90 degrees than 180 degrees.

Corner Posts:

Step 3:

Enter Gate End Posts. These posts are either latch or hinge posts as illustrated. Also they serve as end posts because a panel must also attach to it. Do not include a gate post if it is free standing without a panel attached to it.

Gate End Posts:

Step 4:

Enter End Posts. These posts terminate a line of fence. Only one panel is attached to an end post.

End Posts:

Enter Free Standing Gate Posts. 'AA' illustrates a free standing gate post. These posts are a gate hinge or latch post, but do not have a panel attached to them. In this example you could latch to the house in which case, you do not need a post. We recommend a post in most cases. We do not recommend using one of these posts as a hinge post, because sagging of the gate due to a leaning post is more likely. Try to rearrange your layout to avoid that.

Free Standing Gate Posts:

Step 5:

Enter Walk Gates (Single Swing Gates). Gate 1 is a single swing gate. Choose the opening width of the gate and enter the quantity.

Gate

 Width (ft) Quantity
Walk #1
Walk #2

Step 6:

Enter Drive Gates (Double Swing Gates). Gate 2 is a double swing gate. Choose the opening width of the gate and enter the quantity.

Gate

 Width (ft) Quantity
Drive #1
Drive #2
Click for FencePlace.com Step 7:

You are done. Click 'DONE'

Phone Orders: 1-866-888-5350           About Us   |   Privacy Policy